Warmer Drawer Removal

Removing & Replacing Warmer Drawer

Pull up with finger

Left Glide

Remove shield o_

glide. Pull up on left lever while pushing down on

right lever.

Push down with finger

Fig. 1

Ig Glide

Fig. 2

To Remove and Replace Warmer (Warm &

Ready TM) Drawer

Electrical Shock Hazard can occur and result in serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer.

To Remove Warmer Drawer:

1.Turn power OFF before removing the warmerdrawer.

2.Open the drawer to the fully opened position.

3.On the right glide you will find a shield attached with a hex-head screw (See Fig. 1). Use a 1/4" socket and ratchet to remove the shield.

. Locate glide lever on each side of drawer, pull up on the

left glide lever and push down on the right glide lever.

5.Pull the drawer away from the range.

To Replace Warmer Drawer:

1.Replace shield on the right glide of the drawer body.

2.Pull the bearing glides to the front of the chassis glide (See Fig. 2).

3.Align the glide on each side of the drawer with the glide slots on the range.

4.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position, If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 2-4. This will minimize possible damage to the bearing glides.

NOTE: The Warmer Drawerwill NOT operate whi!e in the Self-Clean and !_OvenLockout'!modes

34

Page 32
Image 32
Kenmore 790.9662 manual Warmer Drawer Removal, To Remove and Replace Warmer Warm Ready TM Drawer