Kenmore 790.9662 manual Removing & Replacing the Lift-OffOven Door

General Care & Cleaning

•Cleaning Recommendations for the Ceramic Glass Cooktop (cont'd)

•Special Caution for Aluminum Use on the Ceramic Cooktop

•Removing & Replacing the Lift-Off Oven Door

•Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.

•Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.

•Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on

the cooktop which can burn and cause discoloration.

@_BRAS]VE

Special Caution for Aluminum Use on the Ceramic Cooktop:

Door Hinge locations

with oven door

fully open

Fig. 1

Fig. 2

Aluminum Foil =Use of aluminum foil on a hot cooktop will damage the ceramic cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the ceramic cooktop under ANY circumstances.

Aluminum utensils - The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the cooktop. If allowed to boil dry, not only will the utensil be destroyed, but it may fuse to, break or mark the ceramic glass surface, permanently damaging the cooktop surface.

Removing & Replacing the Lift-OffOven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open oven door completely (horizontal with floor- See Fig. 1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (See Fig. 2). A tool such as a small flat-blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - See Fig. 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (See Fig. 4).

iii...........

22

	To Replace		Oven Door:
Oven	1.	Firmly grasp both sides of oven door along the door sides (Do not use the
Door-		oven door handle - See Fig. 3).
	2.	Holding	the oven door at the same angle as the removal position, seat the
		hook of the hinge arm over the roller pins located on each side of the oven
		door frame (See Fig. 4). The hook of the hinge arms must be fully seated
		onto the	roller pins.
	3.	Fully open the oven door (horizontal with floor- See Fig. 1).
Fig. 3	4.	Push the door hinge locks up towards and into the oven frame on both left
		and right oven door hinges (See Fig. 2) to the locked position.
	5.	Close the oven door.

Door Care Instructions = Most oven doors contain glass that can break.

Read the following recommendations:

1.	Do not	close	the oven	door until all the	oven racks are fully in place.
2.	Do not	hit the glass with pots, pans, or any other object.
3.	Scratching,		hitting, jarring or stressing		the glass may weaken its structure
Fig. 4	causing an increased			risk of breakage	at a later time.

39