Kenmore 790.9911 manual Setting the Clock, Instructions, Pressdisplay

Setting the Clock

FEATURE OVERVIEW

Setting the Clock Changing between 12 or 24 hour display

Setting the Clock

The CLOCK (_ pad is used to set the clock. The clock may be

set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Fig. 1).

INSTRUCTIONS

To set the clock (example below for 1:30):

Fig. 1

PRESSDISPLAY

1.	Press	(_).	"CLO"	will	appear	in the display (Fig. 2).
2.	Press	O	_	@	pads	to set the time of day to 1:30

(Fig. 3). "CLO" will appear in the display. Press (_.

"CLO" will disappear and the clock will start (Fig. 4).

O

OG)Q

Fig. 2

Fig. 3

Changing between 12 or 24 hour time of day display:

1. Press and hold (_) for 6 seconds (Fig. 3). While holding

Q for 6 seconds

the pad down the current time of day will remain and "CLO" will disappear from the display (Fig. 4). CONTINUE holding the pad until a beep is heard.

2.The display wilt show either "12Hr"(Fig. 5) or "24Hr"(Fig. 6).

3. Press _	to switch between the 12 and 24 hour time of
day display. The display will show either "12Hr" (Fig. 5) or
"24Hr"	(Fig. 6).

4.Press (_ to accept the desired change or press _ to reject the change.

. Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was

chosen, the clock will now display time from 0:00 through 23:59 hours.

Fig. 4

Fig. 5

Fig. 6

17