Kenmore KWX - 5V, KWX - 9V, KWX - 8V, KWX - 3V For Your Safety, What to do if YOU Smell GAS

You may avoid inconvenience and service calls by checking these points before you call for service.

FOR YOUR SAFETY

WHAT TO DO IF YOU SMELL GAS

1.Do Not try to light any appliance.

2.Do not touch any electric switch, do not use the phone.

3.Leave the building Immediately, then call your gas supplier.

4.If you cannot reach the gas supplier, call the fire department.

Possible Cause

Thermostat is not set correctly Burner is not operating properly

No electric power to boiler

Controls out of adjustment Radiators not heating

Circulating pump not running Poor electrical contact Rollout switch blown

Spill switch blown

Vent damper not operating

What to do

Reset thermostat above room temperature.

Check flame. If it is yellow, the burner is not getting enough air. Or, if flame

is blue and noisy and seems to lift off the burner, the burner is getting too much air. Contact your service technician.

Check overcurrent protection. Check to be sure electric power supply circuit is "ON."

Reset according to instructions.

Open radiator vents to vent excess air. Check flow control valve (if used). It may be in closed position.

Check overcurrent protection. Check relay operation.

Check all control terminals and wire joints.

Have your service technician check heat exchanger for blockage. Replace rollout switch with exact replacement.

Have your service technician check venting system and chimney for blockage, or down draft condition. Reset spill switch.

Consult troubleshooting guide in Effikal manual, packaged with vent damper.

Possible Cause	What to do
Gas input amount is incorrect	Contact your service technician,

Possible Cause	What to do
Dirt on seat	Open valve manually Allow water to run and clear valve seat.
Water logged expansion tank	Drain tank, see instructions.

HAVE YOUR SERVICE TECHNICIAN CHECK ANY PROBLEM YOU ARE UNABLE TO CORRECT.

27