Kenmore ULTRAFILTER 500, ULTRAFILTER 300 625.384720 manual Care Of Your Reverse Osmosis System

- CARE OF YOUR REVERSE OSMOSIS SYSTEM -

TUBING CONNECTION (continued) AUTOMATIC SHUTOFF SERVICE

To Disconnect Tubing: Push the collet inward and hold with a finger while pulling the tubing out.

FIG.	11-A]		Tubing correctly cut and connected
	cut	tubing	_uare	oollet _._
	L		1
	I	I	I
	end of tubing round and
	smooth,	with	no cutS,	11/1_'{1N" ub
	nicks or flat spots
FIG.	11-B]			Replacing		collct and
				o-ring		seal
	collet (depress to			Push o-ringseal into
				bottom	of	port, then
	remove,tubing)			fellow	with	collet.

_ltting

collet

Changing CoUet and O-ring (FIG. 11):

1.VClth a small screwdriver remove the coUet and o-

ring from the fitting, Be careful not to scratch the in- ternal walls of the coUet port.

If the shutoff assembly requires service, be sure to reassemble parts exactly as shown in FIG. 12.

FIG. 12	]
screw	(4)	ASSEMBLY
		SHUTOFF

diaphragm

o-ring

plunger

vaJve check

spacer ring

diaphragm

2.Be sure the port is dean, then lubricate and insert the o-ring seal to the bottom of the port.

3.Push the collet inward until it locks in :place,

r									1
I					CAUTION				I
[									[
[ CLEANERS ON THIS RO SYSTEM. THEY WILL [
[ DEGRADE SOME Re SYSTEM PARTS, ALWAYS [
[	USE SOAP		AND	WATER.					[
I.	....................								J
r
[	This reverse		osmosis		system	contains a replaceable			[
[	treatment	componertt			critical	for	effective	removal	[
[	of total	dissolved		solids. The		water	should	be tested	[
[	periodicallytoverifythesystemisperformingsatis-								[
[	factorily.								I
I.	....................								J

%.J

14

Problems, Questions? Call 1-800-426-9345 Kenmore Water Line