-STEP 5: INSTALL STORAGE TANK, MAKE REMAINING TUBING CONNECTIONS -
1. CONNECT DRAIN TUBING, FAUCET TO
DRAIN ADAPTER: Referring to FIG. 8, run the loose section of black 3/8" tubing from the faucet to the
drain adapter, with a black collet, installed on page
6.Cut this tubing as needed to route in as straight of
a run as possible, without loops, dips, low spots or kinks. Cut the end of the tubing square. Then push all the way into the fitting. Pull on the tubing to be sure it's held firmly in the adapter fitting. See pages
13and 14 for tubing connection instructions.
2. CONNECT TUBING TO WATER SUPPLY: Con- nect the feed (green) tube to the water supply fitting
installed on page 5. Connection to the fitting is as de-
scribed in Fig. 11, page 14.
3.Move the storage tankinto place next to the RO as-
sembly. You can stand the tank upright, or lay it on side. Apply no more than two wraps of Teflon tape
to the threads on the nipple at the top of the tank.
Hand tighten the other included tubing adapter fit- ting with the yellow collet onto the tank nipple, then
wrench 1/4 turn only. BE CAREFUL NOT TO CROSS THREAD.
4.Run the 3/8" yellow tubing to the fitting installed in step 3. Be sure the end of the tubing is cut square, and insert all the way into the fitting. Again, pull on the tubing to be sure it's held firmly in the fitting.
TYPICAL UNDERSINK INSTALLATION
FIG. 8 ]
RO prod ucl: water faucet
|
| 3/8" BLACK TUBING |
|
water supply |
| Note: See note on page 4 | |
fitting | drain | regarding tubing lengths. | |
| |||
| adap_r |
|
|
| HOT CeLD | telephone | cable |
| ""sink | ||
| monitored | models | |
|
| only |
|
tubing adapto_ | yellow toilet |
|
|
\
8
Problems, Questions? Call
