Kenmore W10215709A manual Refrigerator Features, Turning the Ice Maker On/Off

Flushing the Water System After Changing Filter

After connecting the refrigerator to a water source, flush the water system. Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it for

5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) for an additional 5 minutes. This will flush air from the filter and water dispensing system. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser.

Using the Dispenser Without the Water Filter Cartridge

You can run the dispenser without a water filter cartridge. Your water will not be filtered.

1.Remove the filter by pressing the eject button and pulling on the cap. See "Changing the Water Filter" earlier in this section.

2.Remove the cap by turning it counterclockwise until it stops. IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

3.With the cap in a horizontal position, insert the cap into the base grille until it stops.

4.Turn the cap counterclockwise until the cap slips into the attachment slot. Then, turn the cap clockwise until it is in a horizontal position.

NOTE: The cap will not be even with the base grille.

Turning the Ice Maker On/Off

The On/Off switch is located on the top right side of the freezer compartment.

1.Slide the control to the ON (left) position.

NOTE: Your ice maker has an automatic shutoff. The ice maker sensor passes a beam from one freezer wall to the other, automatically stopping ice production when the storage bin is full. The control will remain in the ON (left) position.

2.To manually turn the ice maker off, slide the control to the OFF (right) position.

Removing and Replacing the Storage Bin

1.Hold the base of the storage bin with both hands and press the release button to lift the storage bin up and out.

NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the storage bin. The sensor cover ("flipper door") on the left wall of the freezer stops the ice maker from producing ice if the door is open or the storage bin is removed.

2.Replace the storage bin on the door and push down to make sure it is securely in place.

_s

/

Remember

•Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container.

•Discard the first three batches of ice produced to avoid impurities that may be flushed out of the system.

•The quality of your ice will be only as good as the quality of the water supplied to your ice maker.

•Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of

the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is

operating properly and is well maintained.

•It is normal for the ice cubes to be attached at the corners. They will break apart easily.

•Do not store anything on top of the ice maker or in the storage bin.

REFRIGERATOR FEATURES

Your model may have some or all of these features. Features that can be purchased separately as product accessories are labeled with the word "Accessory." Not all accessories will fit all models. If you are interested in purchasing one of the accessories, please call the toll-free number on the back cover or in the "Accessories" section.

Important information to know about glass shelves and covers:

Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping.

Tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use both hands when removing them to avoid dropping.

14