Maintenance

Lamp Unit Replacement Procedure

To prevent burns, wait one hour or longer after the lamp has been switched off before performing the following pro- cedure.

1Remove the lamp unit cover

Using a minus screwdriver, loosen the screws of the lamp unit cover, pull in the direction of the arrow, and remove the cover.

2Loosen the mounting screws of the lamp unit

Using a minus screwdriver, loosen the 2 screws of the lamp unit.

3Pull out the lamp unit

Hold the handle of the lamp unit and pull it up and out.

4Install a new lamp unit

Take the lamp unit and press it into the projector.

Check that the two positioning prongs on the bottom of the lamp unit are securely fit into the two holes.

Tighten the 2 mounting screws of the lamp unit.

Align the 2 tabs located on the lamp unit cover with the projector and attach from the side of the tabs. Tighten the mounting screws of the lamp unit cover.

 

 

4

3

1

4

 

 

Positioning protrusions

 

 

3

 

2

 

E-44