Kenwood DPX-MP2090U System Q, Exit Audio Control mode Volume control mode, Sound setting

System Q

Selecting the best sound setting preset for different types of music.

1Select the source to set Press the [SRC] button.

2Select the Sound type Press the [Q] button.

When you press the button once, the current sound setting is displayed.

Each time you press the button, the sound setting alternates.

Sound setting	Display
User memory	"USER"
Rock	"ROCK"
Pops	"POPS"
Easy	"EASY"
Top 40	"TOP 40"
Jazz	"JAZZ"
Natural	"NATURAL"

•User memory: The values set on the <Audio Control> (page 11).

•Change each setting value with the <Speaker Setting> (page 13).

First, select the speaker type with the Speaker setting.

Audio Control

1Select the source to adjust Press the [SRC] button.

2Enter Audio Control mode Press the [VOL] knob.

3Select the Basic Audio item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Adjust the Basic Audio item Turn the [VOL] knob.

Adjustment Item	Display	Range
Rear Volume *1	"R-VOL"	0 — 35
Subwoofer level*2,3	"SW L"	–15 — +15
Bass level*4	"BAS L"	–8 — +8
Middle level*4	"MID L"	–8 — +8
Treble level*4	"TRE L"	–8 — +8
Balance	"BAL"	Left 15 — Right 15
Fader*3	"FAD"	Rear 15 — Front 15

Exit Audio Control mode (Volume control mode)

•*1 You can control this item when "2ZON" of <Audio Setup> (page 12) is set to "ON".

•*2 You can control this item when <Switching preout> (page 27) is set to "SWPRE SW".

•*2 You can control this item when <Subwoofer Output> (page 13) is set to "SW ON".

•*3 You can control this item when "2ZON" of <Audio Setup> (page 12) is set to "OFF".

•*4 You can adjust these items in detail. Refer to <Adjusting the detail of Audio Control>(Page12).

•*4 Source tone memory: Puts the set up value in the memory per source. (Detail Audio item is included)

5Exit Audio Control mode Press any button.

Press a button other than the [VOL] knob and [ATT] button.

English 11