Troubleshooting Guide
HOLD: | The protective circuit in the unit activates |
| when the temperature inside the |
| automatic disc changer exceeds 60°C |
| (140°F), stopping all operation. |
| ➪ Cool down the unit by opening |
| the windows or turning on the air |
| conditioner. As the temperature falls |
| below 60°C (140°F), the disc will start |
| playing again. |
LOAD: | Discs are being exchanged in the Disc |
| changer. |
READING: | The unit is reading the data on the disc. |
IN (Blink): | The CD player section is not operating |
| properly. |
| ➪ Reinsert the CD. If the CD cannot be |
| ejected or the display continues to flash |
| even when the CD has been properly |
| reinserted, please switch off the power |
| and consult your nearest service center. |
PROTECT: | The speaker wire has a |
| touches the chassis of the vehicle, and |
| then the protection function is activated. |
| ➪ Wire or insulate the speaker cable |
| properly and press the reset button. |
NA FILE: | An Audio file is played with a format that |
| this unit can’t support. |
| ➪ |
COPY PRO: | A |
| ➪ |
NO DVICE: | The USB device is selected as a source |
| although no USB device is connected. |
| ➪ Change the source to any source other |
| than USB. Connect an USB device, and |
| change the source to USB again. |
NA DVICE: | An unsupported USB device is connected. |
| ➪ For the supported USB devices, refer to |
| <About USB device> (page 7). |
NO MUSIC: |
|
• The connected USB device contains no | |
| playable audio file. |
| • Media was played that doesn’t have data |
| recorded that the unit can play. |
| ➪ Use media that has data recorded that |
| the unit can play. |
USB ERR: | The connected USB device is rated a |
| current capacity higher than the allowable |
| limit. |
| ➪ Check the USB device with reference to |
| <About USB device> (page 7). |
| Some trouble may have occurred to the |
| connected USB device. |
| ➪ Remove the USB device and then |
| reconnect it. When the same message |
| displays again, use another USB device. |
