Troubleshooting Guide
The messages shown below display your systems condition.
Eject: | • No disc magazine has been loaded in |
| the changer. The disc magazine is not |
| completely loaded. |
| • No CD in the unit. |
No Disc: | No disc has been loaded in the disc |
| magazine. |
TOC ERR: | • No disc has been loaded in the disc |
| magazine. |
| • The CD is quite dirty. The CD is upside- |
| down. The CD is scratched a lot. |
The disc is unreadable. |
➪Press the reset button on the unit. If the “E- 77” code does not disappear, consult your nearest service center.
➪Check the disc magazine. And then press the reset button on the unit. If the
(Blink): | The CD player section is not operating |
| properly. |
➪Reinsert the CD. If the CD cannot be ejected or the display continues to flash even when the CD has been properly reinserted, please switch off the power and consult your nearest service center.
(Blink): | The tape player section is not operating |
| properly. |
➪Reinsert the Tape. If the tape cannot be ejected or the display continues to flash even when the tape has been properly reinserted, please switch off the power and consult your nearest service center.
Protect: | The speaker wire has a |
| touches the chassis of the vehicle, and then |
| the protection function is activated. |
| ➪ Wire or insulate the speaker cable properly |
| and press the reset button. If the “Protect” |
| code does not disappear, consult your |
| nearest service center. |
NA File: | An Audio file is played with a format that this |
| unit can’t support. |
Copy PRO: | A |
Reading: | The unit is reading the data on the disc. |
Hold: | The protective circuit in the unit activates |
| when the temperature inside the automatic |
| disc changer exceeds 60°C (140°F), stopping |
| all operation. |
| ➪ Cool down the unit by opening the |
| windows or turning on the air conditioner. |
| As the temperature falls below 60°C |
| (140°F), the disc will start playing again. |
READ Error: | The file system of the connected USB device |
| is broken. |
| ➪ Copy the files and folders for the USB |
| device again. If the error message is still |
| displayed, initialize the USB device or use |
| other USB devices. |
No Device: | The USB device is selected as a source |
| although no USB device is connected. |
| ➪ Change the source to any source other |
| than USB. Connect an USB device, and |
| change the source to USB again. |
NA Device: | An unsupported USB device is connected. |
| ➪ Remove the USB device without entering |
| the remove mode. |
No
•Media was played that doesn’t have data recorded that the unit can play.
USB ERR/ | (Blink): |
| Some trouble may have occurred to the |
| connected USB device. |
| ➪ Remove the USB device, then cycle the |
| power switch to ON. If the same display is |
| repeated, use another USB device. |
Remove: | The Remove mode has been selected for the |
| USB device. You can remove the USB device |
| safely. |
24