Kenwood DPX-MP3110, DPX-MP4110, DPX-MP5110U Audio Setup, Speaker Setting, Sound Enhancer Select, Range, Display, Display, Display, Speaker type, Sound effect, 1Enter Standby, Turn the Control knob

General Operation

Audio Setup

You can set Sound system, such as follows;

Adjustment Item	Display	Range
Front High Pass Filter	“HPF”	Through/40/60/80/100/120/
		150/180/220 Hz
Rear High Pass Filter	“HPR”	Through/40/60/80/100/120/
		150/180/220 Hz
Low Pass Filter	“LPF”	50/60/80/100/120/Through Hz
Subwoofer Phase	“PHAS”	Reverse (180°)/ Normal (0°)
Volume offset	“V-Off”	–8 — ±0 (AUX: -8— +8)
Loudness	“LOUD”	Off/On
Dual Zone System	“2ZON”	Off/On

⁄

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by “Zone2” of <Menu System> (page 14).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by Control knob.

-Adjust the volume of Rear channel by <Audio Control> (page 7).

-The Audio Control has no effect on sub source.

1 Select the source to adjust Press the [SRC] button.

2Enter Audio Setup modePress the Control knob for at least 1 second.3Select the Audio Setup item to adjust Press the Control knob.4Adjust the Audio setup item Turn the Control knob.5Exit Audio Setup mode

Press the Control knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type as follows;

Speaker type		Display
OFF		“SP Off”
For 5	& 4 in. speaker	“SP 5/4”
For 6	& 6x9 in. speaker	“SP 6*9/6”
For the OEM speaker		“SP OEM”

1Enter Standby

Press the [SRC] button. Select the “STANDBY” display.

2Enter Speaker Setting mode Press the Control knob.

“SP SEL” is displayed.

3Select the Speaker type Turn the Control knob.4Exit Speaker Setting mode Press the Control knob.Sound Enhancer Select

You can play back adding gorgeous heavy bass to the sound.

1 Enter the Sound Effect mode

Press the [SE] button. "SE SEL" is displayed.

2 Select the Sound effect itemTurn the Control knob.

Sound effect	Display
Returns to the normal sound without Sound effect.	“SE Off“
Moves the sound image up a notch and adjusts bass.	“SE Low”
Moves the sound image up two notches and adjusts	“SE High“
bass.
Changes to the value set in <Sound Enhancer	“SE User“
Control>(page 9).

When the Sound effect is ON, the “SE“ indicator is ON.

3Exit the Sound Effect mode Press the [SE] button.

8 DPX-MP5110U/DPX-MP4110/DPX-MP3110