Kenwood DPX-MP6110U Cabin selection, DTA (Digital Time Alignment) setting, X’Over setting, Range, Display, Display, Display, Setting speaker, 1Enter DTA setting mode

Audio Adjustments

Cabin selection

You can compensate the delay of the sound arrival time, which is caused by the installation position of the speakers, by selecting your environment from the following car types;

Car type (rear speaker position)	Display
Not compensating.	“OFF”
Compact car (rear door)	“Compact1”
Compact car (cargo)	“Compact2”
Full size car (rear door)	“Full Size Car1”
Full size car (cargo)	“Full Size Car2”
Station wagon (rear door)	“Wagon1”
Station wagon (cargo)	“Wagon2”
Minivan (rear door)	“Minivan1”
Minivan (cargo)	“Minivan2”
Sport-utility vehicle (rear door)	“SUV1”
Sport-utility vehicle (cargo)	“SUV2”
Minivan Long (rear door)	“Minivan(Long)1”
Minivan Long (cargo)	“Minivan(Long)2”
Calls the value adjusted at <DTA> (page 17).	“User”

1Enter Cabin select modeSelect “SOUND” > “S-SET” > “CABIN”.

For how to select Function Control item, refer to <Function Control> (page 6).

2Select the car type Turn the Control knob.3Exit Cabin select mode Press the [FNC] button.

⁄

•You can compensate the distances in more details by using <DTA> (page 17) function.

In addition, the value specified at <DTA> can be called by selecting “User”.

DTA (Digital Time Alignment) setting

Adjusting fine tuning of the speaker position compensation value specified at <Cabin selection> (page 17).

1Enter DTA setting modeSelect “SOUND” > “S-SET” > “DTA”.

For how to select Function Control item, refer to <Function Control> (page 6).

2Select the speaker you want to set

Setting speaker	Display
Front speaker	“DTA-Front”
Rear speaker	“DTA-Rear"
Subwoofer	“DTA-Sub"

Turn the Control knob and push the center when the desired item is displayed.

3Set the compensation value of the speaker position

Turn the Control knob. Adjust between 0 and 440 cm.

Refer to <Appendix> (page 25) on how to set the compensation value.

4Exit DTA setting mode Press the [FNC] button.

X’Over setting

You can set a X’Over value for the speakers;

Adjustment Item	Display	Range
Front High Pass Filter	“HPF-Front”	Through/40/60/80/100/120/
		150/180/220 Hz
Rear High Pass Filter	“HPF-Rear”	Through/40/60/80/100/120/
		150/180/220 Hz
Low Pass Filter	“LPF”	50/60/80/100/120/Through
		Hz
Subwoofer level	“SUB-W LEVEL”	–15 — +15
Subwoofer Phase	“SW PHASE”	Reverse (180°)/ Normal (0°)

1Enter X’Over setting modeSelect “SOUND” > “S-SET” > “XOVER”.

For how to select Function Control item, refer to <Function Control> (page 6).

2Select the item you want to set

Turn the Control knob and push the center when the desired item is displayed.

3Set the X’Over value Turn the Control knob.

4Exit X’Over setting mode Press the [FNC] button.

English 17