Kenwood DPX-MP6110U Audio Control, Speaker Setting, Audio Setup, Range, Range, Display, Display, Display, Speaker type, 1Enter Standby, 5Exit Audio Setup mode

Audio Adjustments

Audio Control

You can adjust following Audio Control items ;

Adjustment Item	Display	Range
Rear volume	“REAR VOLUME”	0 — 35
Balance	“BALANCE”	Left 15 — Right 15
Fader	“FADER”	Rear 15 — Front 15

Exit Audio Control mode (Volume control mode)

1Select the source to adjust

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Audio Control mode Press the [AUD] knob.3Select the Audio item to adjust Press the [AUD] knob.4Adjust the Audio item Turn the [AUD] knob.5Exit Audio Control mode Press any button.

Press a button other than the [AUD] knob or [0] and [ATT] button.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type as follows;

Speaker type		Display
OFF		“OFF”
For 5	& 4 in. speaker	“5/4inch”
For 6	& 6x9 in. speaker	“6x9/6inch”
For the OEM speaker		“O.E.M.”

1Enter Standby

Select the “STANDBY” display.

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Speaker Setting mode Press the [AUD] knob.

“SP SEL” is displayed.

3Select the Speaker type Turn the [AUD] knob.4Exit Speaker Setting mode Press the [AUD] knob.

20 DPX-MP6110U

Audio Setup

You can set Sound system , such as follows;

Adjustment Item	Display	Range
Volume offset	“VOL-OFFSET”	–8 — ±0 (AUX: -8— +8)
Dual Zone System	“2 ZONE”	OFF/ON

⁄

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by “Zone2” of <Function Control> (page 6).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [AUD] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 20) or [5]/[∞] button on the remote control

(page 22).

-The Audio Control has no effect on sub source.

1 Select the source to adjust

For how to select source item, refer to <Power/ Source Select button> of <Basic Operation> (page 4).

2Enter Audio Setup modePress the [AUD] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [AUD] knob.4Adjust the Audio setup item Turn the [AUD] knob.5Exit Audio Setup mode

Press the [AUD] knob for at least 1 second.