Playing USB (iPod) device

When the USB device is not connectedConnect the USB device

Playback of the file contained in the USB device starts.

When the USB device is connectedSelect USB source

Press the [SRC] button.

Select the "USB" (or "iPod") display.

⁄

•For the audio files that can be played with this unit and the devices that can be connected to this unit, refer to <About Audio file> (page 5).

•The word "iPod" appearing in this manual indicates the iPod connected with the KCA-iP200 (optional accessory). Refer to <About Audio file> (page 5).

•If you start playback after connecting the iPod, the music that has been played by the iPod is played first.

In this case, "RESUMING" is displayed without displaying a folder name, etc. Changing the browse item will display a correct title, etc.

•When the iPod is connected to this unit, "KENWOOD" or "✓" is displayed on the iPod to indicate that you cannot operate the iPod.

•When the USB device is connected to this unit, it can be charged up provided that this unit is powered.

•When the Multi Card Reader is used, refer to <Drive Search> (page 19).

•After you stopped playing a file contained in the USB device, you can restart playing the file from the point where you stopped its playback.

Even after removing the USB device, you can restart playing the file from the point where you stopped its playback as long as the files contained in the USB device are all the same.

•Be sure to insert the USB device connector as far as it will go.

•You can play the file made by KENWOOD Music Editor by the same operation.

Pause and play

Press the Control knob.

Each time you press the knob, the audio pauses or plays.

Removing the USB device

1Set the remove mode as the USB source Press the [0] button for at least 2 seconds. "REMOVE" display blinks.

2Remove the USB device.

Drive Search

Selecting the device inserted in the Multi Card Reader.

1Put the playback to pause Press the [S.MODE] button.

2Select a device

Push the Control knob towards up or down.

3Restart playbackPress the [S.MODE] button.

⁄

•This unit is compliant with Multi Card Readers with a maximum of 4 slots.

•If a device is inserted during connection of the Multi Card Reader, it is not recognized. Select the Remove mode with reference to <Playing USB (iPod) device> (page 19), remove the Card Reader, and then insert the memory.

English 19