The following items cannot be registered.

Volume, Balance, Fader, Loudness, Volume offset, Dual Zone System, Rear Volume

Other than Standby mode

Audio Preset Recall

Recalling the sound setup registered by <Audio Preset Memory> (page 30).

1Select the source Press the [SRC] button.

2Enter Menu mode

Press the [MENU] button for at least 1 second. "MENU" is displayed.

3Select Audio Preset mode

Push the Control knob towards up or down. Select the "A-PRESET" display.

4Enter Audio Preset mode

Press the Control knob for at least 1 second.5Select the Audio Preset RecallPush the Control knob towards up or down. Select the "RECALL" display.6Recall the Audio Preset

Press the Control knob for at least 2 seconds. The "RECALL" display blinks 1 time.

7Exit Audio Preset mode Press the [MENU] button.

The User memory of <System Q> (page 8) is changed to the value which was recalled.

The source tone memory item of <Audio Control> (page

8)is changed to the value which was recalled by the selected source.

In Standby mode

Firmware version display

Displaying the firmware version with the unit.

1Select the firmware version display mode Push the Control knob towards up or down. Select the "F/W VER" display.

2Display the firmware version

Push the Control knob towards right or left.

In Standby mode

Demonstration mode Setting

Sets the demonstration mode.

1Select the Demonstration modePush the Control knob towards up or down. Select the "DEMO" display.2Set the Demonstration mode

Press the Control knob for at least 2 seconds. Each time you press the knob at least 2 seconds, the Demonstration mode alternates between the settings shown in the table below.

Display

Setting

"DEMO ON"

The Demonstration mode function is ON.

"DEMO OFF"

Exit Demonstration mode (Normal mode).

English 31