before using your Kenwood appliance
●Read these instructions carefully and retain for future reference.
●Remove all packaging and any labels.
safety
●The blades and discs are very sharp, handle with care. Always hold the knife blade
by the finger grip 
at the top, away
from the cutting edge, both when handling and cleaning.
●Do not lift or carry the processor by the handle - or the handle may break resulting in injury.
●Always remove the knife blade before pouring contents from the bowl.
●Keep hands and utensils out of the processor bowl and liquidiser jug whilst connected to the power supply.
●Switch off and unplug:
●before fitting or removing parts
●after use
●before cleaning
●Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.
●Before removing the lid from the bowl or liquidiser/mill from the power unit:-
●switch off;
●wait until the attachment/blades have completely stopped;
●be careful not to unscrew the liquidiser jug or mill from the blade unit.
●Allow all liquids to cool to room temperature before placing them in the liquidiser.
●Do not use the lid to operate the processor, always use the on/off speed control.
●This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.
●Never use an unauthorised attachment.
●Never leave the machine on unattended.
●Never use a damaged machine. Get it checked or repaired: see ‘service’.
●Never let the power unit, cord or plug get wet.
●Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
●Do not exceed the maximum capacities stated.
●Do not let infirm people use the appliance without supervision.
●Do not let children use or play with the appliance.
●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.
before plugging in
●Make sure your electricity supply is the same as the one shown on the underside of your machine.
●This appliance complies with European Economic Community Directive 89/336/EEC.
before using for the first time
1Remove all packaging including the plastic blade covers from the knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade during manufacture and transit only.
2Wash the parts see ‘cleaning’
3Push excess cord into the back of the machine.
key
processor
power unit detachable drive shaft bowl
lid
feed tube pushers safety interlocks cord storage speed control
liquidiser
filler cap lid
jug
sealing ring blade unit
additional attachments
Not all of the attachments listed below may be included with your food processor. Attachments are dependent upon the model variant.
knife blade dough tool
twin beater geared whisk
thick slicing/coarse shredding disc thin slicing/fine shredding disc fine (Julienne style) chipper disc rasping disc
geared citrus press mill
mini processor bowl
KENSTORE™ attachments carousel spatula
2
