To wind tape at high speed
To fast wind in | To fast wind in |
direction | direction \ |
4¢
÷Press the 7STOP key to stop fast winding.
Selection of TAPE equalizer (TAPE EQ.)
(Remote control unit only)
When playing a tape prerecorded with Noise Reduction system (such as the DOLBY NR) ON, be sure to set the "TAPE EQ." ON for playback.
|
|
|
| TAPE EQ. | Lit when “TAPE EQ.” is ON |
|
|
|
|
| TAPE EQ. |
Each press switches the modes as follows. | |||||
|
| 1 | “TAPE EQ.” ON | TAPE equalizer is used. | |
|
| ||||
|
| 2 | “TAPE EQ.” OFF | TAPEequalizerisnotused. | |
|
| ||||
÷Select the "TAPE EQ." ON mode according to the recording condition of the tape.
0000 
TAPE STOPREW
÷Normal (TYPE 
), high (TYPE 
), or metal (TYPE 
) tape selection is set automatically.
÷Remove tape slack before loading.
Playback of tape 19
To stop playback
STOP
7
Selection of reverse mode (Main unit only)
1Select “TAPE RVS. ?”.
menu
up
volume/ multi control
set/demo
down
(Press the set/demo key while the “?” mark is blinking.)
2Select. | up |
| |
volume/ |
|
| |
multi control |
|
| |
down |
|
| |
1 “ ” : (REVERSE) |
| Basic | |
Both sides are played back (recorded), and then the | |||
| |||
tape stops. |
| section | |
2 “ ”:(ENDLESS) |
| ||
|
| ||
Both sides are played back endlessly. |
| ||
(The tape stops after recording onto both sides.) |
| ||
3“
”:
Only one side is played back (recorded), and then the tape stops.
(The initial setting is "
" (REVERSE).
3Set it.
set/demo
Tape counter
Reverse mode indication
0152 
TAPE PLAYREW
Transport direction indicators
Displayed when the deck is loaded with a tape.
A tip for use of the tape counter
The tape counter is set to “0000” when a cassette tape is loaded. By writing down the counter reading in case you want to interrupt recording (playback) in the middle of the tape, the memo will be helpful as a reference for locating the same position when continuing the recording (playback) the next time. The tape counter figure decrements during recording or playback of the back side (while the 2 tape transport indicator is lit). To set the tape counter to “0000”, open the cassette holder once. Then the counter will be reset.
Do not use a cassette with more than