Kenwood KDC-D300 instruction manual English, Removing the hard rubber frame, Removing the Unit

	Installation
English	■ Removing the hard rubber frame
	1 Engage the catch pins on the removal tool and remove the two
	locks on the lower level.
	Lower the frame and pull it forward as shown in the figure.
	Catch
	Lock

Accessory1

Removal tool

2When the lower level is removed, remove the upper two locations.

NOTE

The frame can be removed from the top side in the same manner.

■Removing the Unit

1Refer to the section “Removing the hard rubber frame” and then remove the hard rubber frame.

2Remove the Hex-head screw with integral washer (M4⋅8) on the back panel.

3Insert the two removal tools deeply into the slots on each side, as shown.

Accessory2 Catch facing up

4Lower the removal tool toward the bottom, and pull

out the unit halfway whilst pressing towards the inside.

2CAUTION

Be careful to avoid injury from the catch pins on the removal tool.

5Pull the unit all the way out with your hands, being careful not to drop it.

— 12 —