Kenwood KDC-MP443U, KDC-MP5043U, KDC-MP543U Audio Control, Audio Setup, Speaker Setting, Range, Range, Display, Display, Display, Speaker type, 1Enter Standby, 5Exit Audio Setup mode

Audio Adjustments

Audio Control

You can adjust following Audio Control items;

Adjustment Item	Display	Range
Subwoofer level	“SW L”	–15 — +15
Bass Boost	“B.BOOST”/ “B.B”	“1”/”2”/“OFF” (The
		indicator turns on
		according to the setting.)
System Q	“NATURAL”/ “ROCK”/	Natural/Rock/Pops/Easy/
	“POPS”/ “EASY”/	Top 40/Jazz/Game/User
	“TOP40”/ “JAZZ”/	setting
	“GAME”/ “USER”
Bass level*	“BAS L”	–8 — +8
Middle level*	“MID L”	–8 — +8
Treble level*	“TRE L”	–8 — +8
Balance	“BAL”	Left 15 — Right 15
Fader	“FAD”	Rear 15 — Front 15

Exit Audio Control mode (Volume control mode)

*Source tone memory: Puts the set up value in the memory per source.

⁄

•“USER”: This appears when Bass level, Middle level, and Treble level are adjusted. When “USER” is selected, these levels are recalled.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Control mode Press the [AUD] knob.3Select the Audio item to adjust Press the [AUD] knob.4Adjust the Audio item Turn the [AUD] knob.5Exit Audio Control mode Press any button.

Press a button other than the [AUD] knob.

Audio Setup

You can set Sound system, such as follows;

Adjustment Item	Display	Range
Low Pass Filter	“LPF”	80/120/160/Through(OFF) Hz
Volume offset	“V-OFF”	–8 — ±0 (AUX: –8— +8)

⁄

•Volume offset: Sets each source’s volume as a difference from the basic volume.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup modePress the [AUD] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [AUD] knob.4Adjust the Audio setup item Turn the [AUD] knob.5Exit Audio Setup mode

Press the [AUD] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type as follows;

Speaker type		Display
OFF		“SP OFF”
For 5	& 4 in. speaker	“SP 5/4”
For 6	& 6x9 in. speaker	“SP 6*9/6”
For the OEM speaker		“SP OEM”

1Enter Standby

Press the [SRC] button. Select the “STANDBY” display.

2Enter Speaker Setting mode Press the [AUD] knob.3Select the Speaker type Turn the [AUD] knob.4Exit Speaker Setting mode Press the [AUD] knob.

12 KDC-MP5043U/ KDC-MP543U/ KDC-MP443U