-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 13).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the internal auxiliary input.

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Speaker Setting mode Press the [VOL] knob.

"SP SEL" is displayed.

3Select the Speaker type Turn the [VOL] knob.

Each time you turn the knob, the setting alternates between the settings shown in the table below.

Speaker type

Display

OFF

 

"OFF"

For 5

& 4 in. speaker

"5/4 inch"

For 6

& 6x9 in. speaker

"6x9/6 inch"

For the OEM speaker

"O.E.M."

4Exit Speaker Setting mode Press the [VOL] knob.

Subwoofer Output

Turning the Subwoofer output ON or OFF.

Push the Control knob toward [AM] for at least 2 seconds.

Each time you push the knob, Subwoofer output switches ON and OFF.

When it is ON, "SW ON" is displayed.

•You can control this function when "2 ZONE" of <Audio Setup> (page 14) is set to "OFF".

TEL Mute

The audio system automatically mutes when a call comes in.

When a call comes in

"CALL" is displayed.

The audio system pauses.

Listening to the audio during a call

Press the [SRC] button.

The "CALL" display disappears and the audio system comes back ON.

When the call ends

Hang up the phone.

The "CALL" display disappears and the audio system comes back ON.

•To use the TEL Mute feature, you need to hook up the MUTE wire to your telephone using a commercial telephone accessory. Refer to <Connecting Wires to Terminals> (page 59).

Faceplate Angle Adjustment

Press the [ANG] button for at least 1 second.

•Do not apply excessive force to the faceplate. It can cause damage.

English 15