G-Analyzer Stop Watch
The control of stop watch can be started by G- Analyzer function.
•Do not use
1Select G-Analyzer Stop Watch mode
Push the Control knob towards [FM] or [AM]. Select the "Stop Watch" display.
2Enter G-Analyzer Stop Watch mode
Press the Control knob for at least 1 second. "Stop" is displayed.
3Enter Counter Ready mode Press the Control knob. "Ready" is displayed.
4Start Count
When G in the vertical direction is detected during the travel, the count automatically starts. "Running" is displayed.
•You can also start the counter by pressing the Control knob.
5Stop Count
Press the Control knob. "Stop" is displayed.
•The control will start again when you accelerate or press the Control knob.
Do the operation after step3.
When you Reset the Count (While "Stop" is displayed)
Press the Control knob for at least 2 seconds.
• You can reset of count when the count is stopped.
6Exit
•When "Running" is displayed (counted), the count is continued even though
•When Power off (ex; ACC OFF) while counting, the value of 1 second or less will be "00".
Other than Standby mode/
When the Dual Zone System is ON
Dual Zone System Setting
Setting the Front channel and Rear channel sound in the Dual Zone System.
Display | Setting | |
"Zone 2 | : Rear" | Sub source (Auxiliary input source) is to be rear |
|
| channel. |
"Zone 2 | : Front" | Sub source (Auxiliary input source) is to be front |
|
| channel. |
Function of the
Other than Standby mode
B.M.S. (Bass Management System)
Adjust the bass boost level of the external amplifier using the main unit.
Display | Setting |
"AMP Bass : Flat" | Bass boost level is flat. |
"AMP Bass : +6" | Bass boost level is low (+6dB). |
"AMP Bass : +12" | Bass boost level is mid (+12dB). |
"AMP Bass : +18" | Bass boost level is high (+18dB). |
•Refer to the catalog or instruction manual for power amplifiers that can be controlled from this unit.
•For amplifiers, there are the models you can set from Flat to +18 dB, and the models you can set from Flat to +12 dB.
When an amplifier that can only be set to +12 is connected to the unit, "AMP Bass : +18" will not work correctly even if it is selected.
Function of the
Other than Standby mode
B.M.S. Frequency Offset
Setting the central frequency, boosted by B.M.S.
Display | Setting |
"AMP FREQ : Normal" | Boost with the normal central frequency. |
"AMP FREQ : Low" | Drop the normal central frequency 20%. |
English 47