Kenwood KDC-MP832U, KDC-X890 Theft Deterrent Faceplate, Display Type Selection, Removing the Faceplate, Press the Release button, 4Select the display Type, Reattaching the Faceplate

General features

Theft Deterrent Faceplate

The faceplate of the unit can be detached and taken with you, helping to deter theft.

Removing the Faceplate

Press the Release button.

The faceplate is unlocked, allowing you to detach it.

•The faceplate is a precision piece of equipment and can be damaged by shocks or jolts.

•Keep the faceplate in its faceplate case while detached.

•Do not expose the faceplate (and the faceplate case) to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.

Reattaching the Faceplate

1Align the shaft on the unit with the depression on the faceplate.

2Push the faceplate in until it clicks.

The faceplate is locked in place, allowing you to use the unit.

Display Type Selection

Changing the display mode.

1Select the key function section Press the [NEXT] button.

Repeatedly press the button until "DISP" is displayed above the [2] button.

Refer to <Notes on Multi-function Key System> (page 11).

2Enter display control mode Press the [2] ("DISP") button.

3Select the display mode Press the [1] ("MODE") button.

4Select the display Type

Push the Control knob towards [4] or [¢].

Each time you push the knob, the display mode alternates between the display modes shown in the table below.

Display Mode	Display
"Display Type A"	1
"Display Type B"	1
							2
"Display Type C"
		3					4
		3					5
		3					6
"Display Type D"
					4				7
					6
			8	8		8	8	8		8
"Display Type E"	9

1 Graphic display part

2Text display part

3Text icon display part

4 Upper text display part

5 Middle text display part

6 Lower text display part

16 English