— 47 —— 47 —
?Can’t enter Album Select mode.101
✔There’s no folder recorded in the MP3/WMA media.
☞Use a media with levels.
?The songs in the selected folder aren’t played in Album Select
mode.102
✔There are no MP3/WMA in the selected folder.
☞Make sure there’s recorded content in the MP3/WMA media.
?The MP3/WMA track/album search takes time.78
✔Many tracks are recorded on the media.
☞When the media directory is complex, the track/album search can
take time.
?The MP3/WMA related text isn’t displayed correctly.79
✔A character is entered that this unit can't display.
☞For the characters that can be used for MP3/WMA text entry,
refer to <Notes on playing MP3/WMA> (page 6).
?The MP3/WMA track time isn’t displayed correctly.80
✔---
☞There are times when it isn’t displayed correctly according to the
MP3/WMA recording conditions.

If the following situations, consult your nearest service

center:

•Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
•Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87,
KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the
Auxiliary input is entered when switching modes.
Troubleshooting Guide

The messages shown below display your systems

condition.

Eject: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.E01
➪Load the disc magazine properly.
No CD in the unit.
➪Insert the CD.
No Disc: No disc has been loaded in the disc magazine.E02
➪Load a disc into the disc magazine.
TOC Error: The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪Clean the CD and load it correctly.
E-05: The CD is upside-down.E05
➪Load the CD correctly.
Blank Disc: Nothing has been recorded on the MD.E10
No Track Disc: No tracks are recorded on the MD, although it has a
title.E11
No Music Data: Media was played that doesn’t have data recorded
that the unit can play. E15
➪Use media that has data recorded that the unit
can play.
No Panel: The faceplate of the slave unit being connected to
this unit has been removed.E30
➪Replace it.
E-77: The unit is malfunctioning for some reason.E77
➪Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
KDC-M907 _U.S 04.2.4 4:17 PM Page 47