General features

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup modePress the [VOL] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item

Display

Range

Front High Pass Filter*1

"HPF"

Through/40/60/80/100/120/

 

 

150/180/220 Hz

Rear High Pass Filter*1

"HPR"

Through/40/60/80/100/120/

 

 

150/180/220 Hz

Low Pass Filter*1,2

"LPF"

50/60/80/100/120/Through

 

 

Hz

Subwoofer Phase*1,2,3

"PHAS"

Reverse (180°)/ Normal (0°)

Volume offset

"V-OFF"

–8 — ±0

Loudness

"LOUD"

OFF/ON

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume.

•*1 Function of the KDC-W6534U.

•*2 You can control this item when <Switching preout> (page 30) is set to "SWPRE SW".

•*2 You can control this item when <Subwoofer Output> (page 12) is set to "SW ON".

•*3 You can control this item when Low Pass Filter is not set to Through.

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Speaker Setting mode Press the [VOL] knob.3Select the Speaker type Turn the [VOL] knob.

Each time you turn the knob, the setting alternates between the settings shown in the table below.

Speaker type

Display

OFF

 

"SP OFF"

For 5

& 4 in. speaker

"SP 5/4"

For 6

& 6x9 in. speaker

"SP 6*9/6"

For the OEM speaker

"SP OEM"

4Exit Speaker Setting mode Press the [VOL] knob.

Function of the KDC-W6534U

Subwoofer Output

Turning the Subwoofer output ON or OFF.

Push the Control knob toward [AM] for at least 2 seconds.

Each time you push the knob, Subwoofer output switches ON and OFF.

When it is ON, "SW ON" is displayed.

•You can control this function when <Switching preout> (page 30) is set to "SWPRE SW".

12 English