Installation
Removing the hard rubber frame
1Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure.
Lock
Catch
Accessory2
Removal tool
2When the upper level is removed, remove the lower two locations.
⁄
•The frame can be removed from the bottom side in the same manner.
Removing the Unit
1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2Remove the screw (M4 × 8) on the back panel.
3Insert the two removal tools deeply into the slots on each side, as shown.
4Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.
Screw (M4X8) (commercially available)
Accessory2
¤
•Be careful to avoid injury from the catch pins on the removal tool.
5Pull the unit all the way out with your hands, being careful not to drop it.
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it does not fall off.
1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2Drop open the faceplate by pressing the Release button.
3Tighten the screw (ø2 × 5 mm) (Accessory 5) and bracket (Accessory6 ) in the hole shown on the diagram.
Accessory6
Accessory5
4Tighten the screw (ø2 × 5 mm) (Accessory 5) and bracket (Accessory7) in the hole shown on the diagram.
Accessory7
Accessory5
¤
•Never insert the screws in any other screw hole than the one specified. If you screw them in another hole, it will contact and may cause damage to the mechanical parts inside the unit.
36 English