Setting up the system
Connecting the terminals
1 Strip coating. | 2 Push the lever. | ||
|
|
|
|
|
|
|
|
|
|
|
|
3 Insert the cord. | 4 Return the lever. |
•Never short circuit the + and – speaker cords.
•If the left and right speakers are connected inversely or the speaker cords are connected with reversed polarity, the sound will be unnatural with ambiguous acoustic imaging. Be sure to connect the speakers correctly.
Speaker impedance
After confirming the speaker impedance indications printed on the rear panel of this model, connect speakers with matching impedance ratings. Using speakers with a rated impedance other than that indicated on the rear panel of this model could result in malfunctions or damage to the speakers or this model.
Speaker placement
Center speaker
| Subwoofer |
Front |
|
speaker | Listening |
| |
Surround | position |
| |
speaker |
|
* Surround | * Surround |
Back Left | Back Right |
speaker | speaker |
*Surround Back speaker
*For Surround Back speaker, you may place either two Surround Back speakers (Surround Back Left speaker and Surround Back Right speaker) for 7.1 channel surround sound system or one Surround Back speaker for 6.1 channel surround sound system.
Front speakers: Place the left and right speakers at each side of your TV. Angle the speakers towards the listening area to enhance the stereo effect.
Center speaker: Place the center speaker on the center between the front left and right speakers. Tilt the speaker upward or
Surround speakers: Place the surround speakers as high as possible, either directly to the sides of the listening area or else slightly behind the listening area. Adjust the angles so that these speakers are facing directly towards the listeners.
Subwoofer: Usually, place the subwoofer in the front center position in the listening room, near one of the front speakers. (Since the subwoofer has less directivity than other speakers, it can be placed almost in any position that can offer the best low frequency reproduction according to the room layout.)
Surround Back speaker/s: Place the surround back speaker behind the listening position, at the same height as the left and right surround speakers.
•Although the ideal surround system consists of all the speakers listed above, if you don’t have a center speaker or a subwoofer, you
can divide those signals between the available speakers in the speaker settings steps to obtain the best possible surround
reproduction from the speakers you have available. | ^ |
Connecting the antennas
The broadcast reception cannot be made unless the antennas are connected. Connect the antennas correctly as instructed below.
AM loop antenna
Place the supplied loop antenna as far as possible from the receiver, TV set, speaker cords and power cord, and adjust the direction for best reception.
AM antenna terminal connections
1 Push lever. | 2 Insert cord. | 3 Release lever. |
FM indoor antenna
The supplied indoor antenna is for temporary use only. For stable signal reception we recommend using an outdoor antenna. Disconnect the indoor antenna when you connect one outdoors.
FM antenna terminal connections
Insert cord.
FM outdoor antenna
Lead the 75Ω coaxial cable connected to the FM outdoor antenna into the room and connect it to the FM 75Ω terminal.
ANTENNA
AMGND
Attach to the stand
FM indoor antenna
FM outdoor antenna
Use an antenna
adapter
AM loop antenna (Commercially available)