Normal playback
Preparing for playback
Some preparatory steps are needed before starting playback.
SPEAKERS
ON/OFFON/STANDBY
POWER AUTO/MONO INPUT SELECTOR ON/OFF
Turning on this model
1Turn on the power to the related components.
2Turn on the power to this model by pressing the POWER ON/
OFF and ON/STANDBY key.
Listening to a source component
VOLUME CONTROL
INPUT SELECTOR
Input
Selector
VOLUME %/fi
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2, DVD/6CH INPUT jacks, make sure that the input mode setting is correct
for the type of audio signal to be used. | 8 |
Selecting MD/TAPE
Select the source name corresponding to the component connected to the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the source to “MD”, follow the steps below:
1Use the INPUT SELECTOR knob to select “TAPE”.
2Hold down the AUTO/MONO key for more than 2 seconds.
•The source indication changes to “MD”.
•To return to the original indication, repeat procedure 2.
Setting the speaker status
The speaker indicator lights up.
Press the SPEAKERS ON/OFF key to switch the speaker on or off.
1Use the INPUT SELECTOR knob or keys to select the source you want to listen to.
The input sources change as shown below:
1 Tuner (FM/AM broadcast reception)
2“CD/DVD”
3“TAPE” or “MD”
4 “VIDEO1”
5 “VIDEO2”
6 “DVD/6CH”
7 “AUX”
2Start playback from the selected source.
3Use the VOLUME CONTROL knob or VOLUME %/fi keys to adjust the volume.