Kenwood KRF-VBB81 D, VR-2000 instruction manual the remote control transceiver, Preparation

v_q-2oecI/VR-_OaOiKRF-VBB81D/KF_F V777 ! 0 {En/K') "_

The remote control unit provided with this unit can be used to control the components as a system by utilizing a com- mercially available infrared control unit or wired control unit.

By installing the IR RECEIVER and speakers in an other room, the system in another room can be remote controlled,

To control the desired components from another room, set the remote control unit to the Room B control mode.

Preparation

To remote control the components in your AV room as a system, make preparations such as the operations described in "Install-

ing the remote control transceiver", "Making connections to another room (Room B)" and "Setup for multi-room operation".

the remote control transceiver

The fot owing connections (,_:) are only available for VR-2090 sold in the U,S.A. and Canada,

Connect the remote control transceiver, sensor and controller as shown in the illustration.

]R RECEIVER : (Optional, to be released in future) IR RECEIVER IN (_), IR OUT FOR REMOTE {_)) :

These input and output let you connect an external IR receiver to enable remote control of this unit even if it is located in a

cabinet or behind glass doors (etc). The external tR receiver works the same as the IR receiver tocated on the front of this unit. This input ((f}) is compatible witt) Xantech 291-80, 480-30 or 49030. Xantech 29t-80, 480-30 or 490-30 are for use of tR RECEIVER IN ((_) (RC sensor) only.

IR OUr

FOR

REMOTE@

RELAY CONTROL (4_

IR REPEATER OUT (_) : (Optional)

These outputs let you connect JR repeaters to control compo- nents located in cabinets or behind glass doors (etc.) The

repeaters send out signals corresponding to those of the remote control supplied with the respective equJpmenL These outputs are compatibJe with Xantech 282-00, 286-00 or 283-00

The IR REPEATER OUT terminals may

only used when an external IR re- ceiver is connectedto the IR RECEIVER

IN terminal.

RELAY CONTROL (4_): (Optional)

This output is designed to operate exter- nal devices and is compatible with the Xantech 599-00 Pulse Switching Module.

Do not exceed maximum current by co_ necdng multiple 599-00 modules, Please consult the nstruction manual of theex ternal device for compatibility and installa-

tion instructions before attempting con-

	nections to	your new	receiver. Improper
	installation, or connection of non-compat-
	ibre equipment, may damage this control
	output. Please consult the dealer where
REPEATER	the external	equipment	was purchased or

Another maker's codes

Source compoeents (excep_ for models

connected with KENWOOD's

systemcont_ol cordsl

a competent installation speciaJist fo_ more information.

TV ON/OFF SENSOR (_): (Optional) This sensing is used in the "Perfect Macro" fuature to tell the rv ON/OFF,

This input is compatible with JDS: PSSTV

or NILES: LS-1, APC2