Kenwood KRF-X7775D -

35

Setting Up

Setting Up Remote Control Unit

Selecting the input:

Audio device: Press the

MUSIC

button repeatedly. The in-

put names where audio devices are identi-

fied by Remote Control unit will be shown

on the LCD screen.

1CD1 :

2MD/Tape1 :

3Tuner :

4CD-R :

5Phono :

If an audio device which is connected to an

input is not identified by Remote Control

unit, the device name is skipped and not dis-

played.

Video device: Press the

MOVIE

button repeatedly. The input

names where video devices are identified by

Remote Control unit will be shown on the

LCD screen.

1Video1 :

2Video2 :

3Video3 :

5DVD/6ch :

6AV AUX :

Remote Control unit is a new type of remote control unit

which receives information from the receiver and display it

on the LCD screen.

This section describes the basic operations of Remote Con-

trol unit.

Turning power on:

To turn the receiver on: Press the SYS.POWER button.

To turn the connected device on: Press the AV POWER but-

ton.

(It is necessary to perform the procedure in “Identifying

Components for Remote Control Unit” on page 39 to en-

able remote control of AV devices.)

Adjusting the receiver’s volume:

Press the VOL. (+/-) button repeatedly un-

til the desired volume is obtained.

Muting audio temporarily:

Press the MUTE button.

To resume the original volume, press the MUTE button again

or press one of the VOL. (+/-) buttons.

Using the numeric buttons:

When entering a figure directly for selecting a CD track num-

ber, etc., press the numeric buttons as shown below.

To enter 5 :

To enter 25 :

The button to be pressed varies depending on the

function.

+

-

VOL.

Screen menu control operation

2WAY LCD REMOTE CONTROL UNIT

RECREC

The contents of the func-

tion buttons vary according

to current situations, and

the function names (Next,

Back, Enter, etc.) are shown

on the screen.

For details, see the descrip-

tion of each control opera-

tion.

Press to select an item by

scrolling the screen menu

up or down.

The selected item is dis-

played in an inverted color.

Basic Operation of Remote Control Unit

If a video device which is connected to an in-

put is not identified by Remote Control unit,

the device name is skipped and not displayed.

Although VIDEO4 is displayed in the initial

status, the receiver cannot be switched to se-

lect VIDEO4. The VIDEO4 display will not

appear after the Remote Control unit has been

set up.

TV: Press the

button. The LCD screen shows TV if

this is registered in and identified by Remote Control

unit.

01.IR

02.Surround

03.Contrast

Home Enter

LCD

Function

button 1

LCD

Function

button 2