39

Setting Up
Setting Up Remote Control Unit

Identifying Components for Remote Control Unit

After the speaker setup, it is required to make Remote Con-
trol unit capable of identifying the devices it controls. Re-
mote Control unit provided with the receiver can be used
in setup of any device. Even when a device is not listed in
the device codes in the Remote Control unit memory, the
remote control function of the device can be programmed
using the Learn function.
The Learn function can also be used to extend the remote
controllable functions.
For details, see “If a device cannot be remote controlled with
any code in the list, or to add remote control target func-
tions...” on page 40.
Registering a device
1. Ensure that the batteries are loaded.
3. Press the Setup button (LCD function button 2).
4. Select “01. IR” using the or button, then press
the Enter button (LCD function button 2).
2. Press the Menu button (LCD function button 2).
01.IR
02.Surround
03.Contrast
Home Enter
Tuner
FM 01ch
87.50MHz
Menu
Home Setup
Press the MUSIC button or MOVIE button to display
“Menu”.
5. See “Noting Your Devices” on page 3 to check the de-
vices and the jacks to which they are connected.
6. Select a device connection jack name (CD1, MD/Tape1,
etc.) using the or button, then press the Enter
button (LCD function button 2).
7. Select the device name connected to the jack (CD, Tape,
etc.) using the or button, then press the Enter
button.
01.CD1
02.MD/Tape1
03.CD-R
Back Enter
01.CD
02.Tape
03.MD
Back Enter
Kenwood
Adcom
Aiwa
Back Enter
8. Select the manufacturer name of the device using the
or button, then press the Enter button.
If the manufacturer name of the device is not listed, se-
lect "Nothing" and press the Enter button. In this case,
the code can be programmed using the Learn function
(see page 40).
01.0505
02.Nothing
Back Enter
9. Select the setup code of the device (each device has a
remote control identification number matching it) us-
ing the or button.
• When the device is connected through a Kenwood
system control cord, select System. In this case, the
remote control signal is sent to the receiver then to
the device connected to it.