34
Chapter Two : Setting Up Remote Control Unit
Setting Up
Chapter Two: Setting Up Remote Control Unite
This Remote Control unit can be set up to remote control
the receiver as well as most of the devices connected to it.
The appearance and functions of the Remote Control unit
are slightly different from other remote control units. Since
it is used to remote control a large number of devices, its
screen shows the information of each device in separate
menus.
This Remote Control unit can remote control the devices
which are connected to the receiver and identified by the
Remote Control unit.
In case the Remote Control unit cannot remote control a
device you want to use, check if the device has been regis-
tered for identification by the Remote Control unit. The
method of registering devices in Remote Control unit will
be described later in this chapter.
Before you can set up any Remote Control unit item, you
need to install batteries.
• The batteries that came with your new Remote Control
unit are intended for you to use for an operation check—
they may not last as long as ordinary batteries. We rec-
ommend replacing them with batteries for normal use.
To install the batteries:
1. Slide down the battery cover as shown by the figure to
remove it.
2. Insert four AA(R6) batteries with the correct polarity.
Then close the battery cover.
Installing the Batteries
This chapter is composed of the following sections.
Installing the Batteries Page 34
Resetting the Remote Control Unit Page 34
Basic Operation of Remote Control Unit Page 35
Setting Up Speakers Page 36
Identifying Components
for Remote Control Unit Page 39
If Remote Control unit is used outside the remote control
range, the screen may show erroneous information. For the
remote control range, refer to page 7 (“Remote controllable
range”) in the Users’ Guide.
When the remote control range reduces or the Low Battery
indicator ( ) will flash in the LCD screen, replace all of
the four batteries together.
To extend the battery life, we suggest that you keep the back-
light off except when necessary. For the backlight, refer to
the Users’ Guide.
Resetting the Remote Control Unit
The Remote Control unit can be reset in two ways
To reset the remote without clearing the setups:
• Remove the batteries then reload them again.
This resets the Remote Control unit but the speaker
setup and device setup remain unchanged.
To reset everything and initialize the remote to the
factory condition:
1. Remove the batteries.
2. While holding the (function up) button and
button simultaneously, load the batteries.
3. Release the above buttons.
This operation resets all of the setups made by the user.
2WAY LCD REMOTE CONTROL UNIT
+
-
+
-
123
456
789
10 11 12
+10 0 +100
/8
/7
1
1