76
Moving Around
Troubleshooting
With a Dolby Digital program or DTS program, the loud sounds
aren’t very loud and the quiet sounds aren’t very quiet
Check that volume extremes are not automatically being balanced. See
“Midnight Theater Function” on page␣ 16 of this manual.
All I hear is loud static when I play DTS discs
• Check that Digital has been set as the input mode. DTS discs do not
output analog sound. See “Switching Input Modes” on page␣ 23.
• DTS discs can only be played in Zone A
I hear a hum when I select the PHONO input
Check that:
• The audio cables are connected securely to the Phono jack set. See
Chapter One of the Connections and Setup Guide.
• The turntable is grounded on the receiver. See Chapter One of the
Connections and Setup Guide.
Sound is intermittent
Attach the provided protective cap to the unused OPTICAL inputs. If the
light from a fluorescent lamp or direct sunlight enters through this con-
nector, the played audio will be intermittent.
I can’t hear any sound in Zone B
Check that:
• Multiple Zones is activated.
• The volume in Zone B is turned up. See “Operating Devices in Zone
B?” on page␣ 55 of this manual.
• The Zone B speakers are turned on if using Speaker B outputs for
Zone B (as opposed to Second Zone Pre Outs). See “Turning the Speak-
ers On” on page␣ 9 of this manual.
• The source is connected via an analog jack set (digital inputs are not
sent to Zone B). See Chapter One of the Connections and Setup Guide.

Video

I can’t see the program I’m playing on the TV. There wasn’t any
video output to my VCR when I recorded
• Check that the video source and TV are connected via the same type
of connectors (For VR-5080).
Sound / Video