Kenwood Error messages, Additional information, SONY MZ-B3E, Error message Meaning/Remedy

Error messages

If the following error messages flash in the display window, check the chart below.

Error message Meaning/Remedy

BLANKDISC •An MD with no recording on it is inserted.

bInsert a recorded MD.

BUSY	•You tried to operate the recorder while it was accessing the
	recorded data.
	b Wait until the message goes out (in rare cases, it may take
	2–3 minutes).
CANNOT	•You tried to erase a track mark while playing the MD or at the
	beginning of the first track.
	•You tried to erase a track mark to combine tracks the recorder
	cannot combine. (This is caused by system limitation.)

DISC ERR	•The recorder cannot read the disc (it's scratched or dirty).
	b Reinsert or replace the disc.
DISC FULL	•There is no more space on the disc (less than 24 seconds
	available in monaural).
	b Replace the disc.
Hi DC in	•Power supply is too high (The recommended AC power
	adaptor is not used).
	b Use the recommended AC power adaptor.
HOLD	•The recorder is locked.
	b Slide HOLD against the allow to unlock the recorder
	(page 21).
LOW BATT	•Batteries are weak.
	b Replace the dry batteries or charge the rechargeable
	battery (page 6 or 27).

Additional information

NO DISC	•You tried to play or record with no disc in the recorder.
	b Insert an MD.
PB DISC	•You tried to record or edit on a premastered MD (PB means
	playback.)
	b Insert a recordable MD.

PROTECTED •You tried to record or edit on a MD with the tab in the record- protect position.

bSlide the tab back (page 15).

Continue to next page m

35

SONY MZ-B3 (E) 3-798-610-22(1)