Kenwood TH78E, TH-78A Single Band Operation, MHz Mode, Channelized Frequency Display

Notes on simultaneous in Band reception

1 When two signals on the same band are received simultaneously, the receive performance, such as image interference and sensitivity, may be reduced.

2 If the two frequencies are the same, the volume may decrease at some VOL control positions.

To return to normal operation press the f² key again.

10 Single Band Operation

When you press the DUAL key, the band for which the PTT indicator is on is selected, and you can perform a single-band operation with that band.

When you press the BAND key, the band in the single-band operation changes.

Each time you press the DUAL key, you toggle between single-band and dual-band operation.

11 MHz Mode

If you use this function, you can change the frequency in l-MHz steps.

Press the MHz key.

The 100-kHz digit and lower digits of the operation band go blank. When you turn the tuning control, the frequency changes in l-MHz steps.

To return to the normal frequency display, press any front panel key (except E.CHG key) or wait 10 seconds.

12 Channelized Frequency Display

The frequency display can be changed to display channel numbers instead of the operating frequency. This function makes use of the data you have stored in memory for this function. Channel 1 is memory channel 1, Channel 2 is memory channel 2, etc.

1Turn the POWER switch off.

2Press and hold down the 3 key, then press the POWER switch.

Channel number are displayed for both bands

3The channel number can be changed with the tuning control.

4To return to the normal frequency display, perform steps 1 and 2 again.

52