30
7
•Memory Channel numbers L0/U0 ~ L2/U2 {page 40}, Pr
{page 43}, and AL (Weather Alert) {page 36} (K market
models only) are reserved for other functions.
5Turn the Tuning control or press Mic [UP]/[DWN] to
select the Memory Channel in which you want to
store the data.
6Press [MR] to store the data to the channel.
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a pair of reception and transmission
frequencies with a non-standard offset. If you store 2
separate frequencies in a Memory Channel, you can
operate on those repeaters without programming the
offset frequency and direction.
1Store the desired reception frequency and related
data by following steps 1 to 6 given for simplex or
standard repeater frequencies {page 29}.
2Turn the Tuning control or press Mic [UP]/[DWN] to
select your desired transmission frequency.
3Press [F].
4Turn the Tuning control or press Mic [UP]/[DWN] to
select the pre-programmed reception Memory
Channel in which you want to store the data.
5Press [MR] (1s).
•The transmission frequency is stored in the Memory
Channel.
Note:
◆When you recall an odd-split Memory Channel, “+” and “–” appear
on the display. To confirm the transmission frequency, press
[REV].
◆Transmit offset status and reverse status are not stored in
odd-split Memory Channels.
RECALLING A MEMORY CHANNELUSING THE TUNING CONTROL
1Press [MR] to enter Memory Recall mode.
•The Memory Channel last used is recalled.
2Turn the Tuning control to select your desired
Memory Channel.
•You cannot recall an empty Memory Channel.
•To restore VFO mode, press [VFO].