31
7
USING THE MICROPHONE KEYPAD
You can also recall a Memory Channel by entering a
desired Memory Channel number with the microphone
keypad.
1Press [MR] to enter Memory Recall mode.
2Press the microphone key assigned the ENTER
function.
3Enter the channel number using the microphone
keypad.
•For single-digit channel numbers, enter “0” first or press
Mic Enter after entering the channel number.
•For two-digit channel numbers that begin with “1”, press
Mic Enter after entering the channel number.
Note:
◆You cannot recall an empty Memory Channel. An error beep
sounds.
◆You cannot recall the Program Scan Memory Channels
(L0/U0 ~ L2/U2), the Priority Channel (Pr), and the Weather Alert
Channel (AL) (K market models only) using the numeric keypad.
◆When you recall an odd-split memory channel, “+” and “–” appear
on the display. Press [REV] to display the transmission
frequency.
◆After recalling a Memory Channel, you may modify data such as
Narrow Band, Tone, or CTCSS. However, these settings are
cleared once you select another channel or the VFO Mode. To
permanently store the data, overwrite the channel contents.
CLEARING A MEMORY CHANNEL
To erase an individual Memory Channel:
1Recall the Memory Channel you want to erase.
2Press [ ] (Power) (1s) to switch the transceiver
OFF.
3Press [MR]+[ ] (Power).
•An erase confirmation message appears.
4Press [MR] to erase the channel data.
•The contents of the Memory Channel are erased.
•To quit clearing the Memory Channel, press any key
other than [MR].
Note:
◆You can also clear the Priority Channel, the AL Channel, and
L0/U0 ~ L2/U2 data. (The Call Channel cannot be cleared.)
◆To clear all Memory Channel contents at once, perform Full Reset
{page 67}.
◆You cannot clear channels while in Channel Display Mode.