2
1
PREPARATION
2Position the transceiver, then insert and tighten
the supplied hexagon SEMS screws (4) and flat
washers (4).
Double check that all hardware is tightened to prevent
vehicle vibration from loosening the bracket or
transceiver.
Determine the appropriate angle of the transceiver,
using the 3 screw hole positions on the side of the
mounting bracket.

MOBILE INSTALLATION

To install the transceiver, select a safe, convenient
location inside your vehicle that minimizes danger to
your passengers and yourself while the vehicle is in
motion. Consider installing the unit at an appropriate
position so that knees or legs will not strike it during
sudden braking of your vehicle. Try to pick a well
ventilated location that is shielded from direct sunlight.
1Install the mounting bracket in the vehicle using the
supplied self-tapping screws (4), flat washers (4), and
spring washers (4).
The bracket must be installed so that the 3 screw hole
positions on the side of the mounting bracket are
towards the rear of the bracket.
Self-tapping screw
(5 mm x 16 mm)
Flat washer
SEMS
screw
Spring washer