43
8
CALL SCAN
You can alternate between monitoring the Call Channel
and the current operating frequency.
1Select the frequency (in VFO or Memory Recall
Mode) you want to monitor.
•In VFO Mode, turn the Tuning control or press Mic [UP]/
[DWN] to select the desired frequency.
•In Memory Recall Mode, turn the Tuning control or
press Mic [UP]/[DWN] to select the Memory Channel
you want to monitor.
2Press [CALL] (1s) to start the Call Scan.
•The Call Channel and the selected VFO frequency or
memory channel are monitored.
•The 1 MHz decimal blinks while scanning is in progress.
3Press any key other than [F] or [ ] (Power) to stop
Call Scan.
Note:
◆You must configure the CALL key function to “CALL”
(Menu No. 19) prior to using Call Scan. Otherwise, a
1750 Hz tone will be transmitted.
◆You can perform Call Scan even if the recalled Memory Channel
has been locked out {page 44}.
PRIORITY SCAN
You may sometimes want to check your favorite
frequency activities while monitoring other frequencies.
In this case, use the Priority Scan function. Priority Scan
checks the activities of the Priority Channel every
3 seconds. If the transceiver detects a signal on the
Priority Channel, it recalls the frequency to the VFO.
PROGRAMMING A PRIORITY CHANNEL
1Press [VFO] and turn the Tuning control or press Mic
[UP]/[DWN] to select your desired Priority Channel
frequency.
2Select selective call functions, if necessary.
3Press [F].
•The Memory Channel number appears and blinks.
4Turn the Tuning control or press Mic [UP]/[DWN] to
select the Priority Channel (“Pr”).
5Press [MR] to store the data on the Priority Channel.