How Do I Adjust the Sound?

2.Press the MULTI CONTROL (%/fi) button to select the desired vol- ume level, then press the SOUND button repeatedly until “SOUND FIXED” is displayed.

If you select another source device or turn off the receiver, the above setting is reset to the level adjusted in Chapter Two of the Connection and Setup Guide.

Adjusting the Input Level

If the front panel CLIP indicator will flash red continually, lower the analog input level for the source device you’re listening to. (Setting the proper input level eliminates distortion that occurs if a source device’s output level is too high. Occasional brief flashing of the CLIP indicator is okay).

1.Select the input to be adjusted (see “Selecting the Inputs” on page 35).

2.Press the SOUND button on the Remote Control unit until Analog Level is displayed.

Sound

Analog Level

CD1 0dB

Home Next

3.Press the LCD cursor up/down (/) button on Remote Control unit to select the desired input level, then press the Home button.

Select one of the three input levels; 0 dB, -3 dB and -6 dB. (The dB is the unit expressing the amplitude of sound.)

Operation on the receiver:

1.Press the SOUND button inside the door repeatedly until ANLG IN- PUT is displayed.

2.Press the MULTI CONTROL (%/fi) button to select the desired input level, then press the SOUND button repeatedly until “SOUND FIXED” is displayed.

Receiver Using

15