Video/Remote Control unit

•Check that the correct video input on the TV is selected.

•Check that the video software you record does not have copy guard protection.

•All Zone B inputs must be composite. S-Video is not supported in Zone B.

Remote Control unit

My Remote Control unit is slow to respond—sometimes I have to press buttons or select commands several times

•If Remote Control unit is in sleep mode (the screen is blank), the first button press “wakes it up”. The second press performs the action.

•Your Remote Control unit supports 2-way communication with the receiver. If the 2-way communication indicator on the front of the receiver is lit, Remote Control unit is receiving information. It cannot transmit your new command until it is finished receiving informa- tion from the receiver.

My Remote Control unit is not responding

•Make sure you are within the operating range for Remote Control unit. See “Remote controllable range” on page 7 of this manual.

•Replace the batteries. See Chapter Two of the Connections and Setup Guide.

•If you’re using an IR receiver, make sure it is connected properly and turned on. See Chapter four of the Connections and Setup Guide.

•Check the contrast of the LCD display is adjusted properly. See “How Do I Adjust the LCD Display” on page 50.

•When the RF ON/OFF (INPUT MODE) button is pressed for 2 sec- onds or longer, “RF OFF” will be displayed. In this condition, the main unit can not receive remote control signals. Press the RF ON/ OFF (INPUT MODE) button again for at least 2 seconds to display "RF ON". See page 49 of the Connections and Setup Guide.

•If you want to use Remote Control unit by setting the control mode to Zone B, make sure that the Multi-Zone function is On. If this func- tion is Off, you cannot control Zone B from Remote Control unit.

Troubleshooting

75