1 4 Operation of remote control unit

XD-750/700/550/500 (En)

Loading batteries

1 Remove the cover.

2 Insert batteries.

3 Close the cover.

section

÷ Insert two R6 (“AA”-size) batteries fol- lowing the polarity indications.

Operation

Preparation

Plug the power cord into the mains power outlet and press

the (on/standby) key of the remote control unit to turn power ON. After the power has been turned ON, press the desired key.

To turn power off, press the (on/standby) key again. The system enters the standby mode in which only the time display is lit.

÷When pressing more than one remote control keys successively, press the keys securely by leaving an interval of 1 second or more between keys.

Remote sensor

6 m

30° 30°

Model: RC-H3R/H2R

Infrared ray system

Operating range (approx.)

 

1.

The provided batteries are intended for use in operation checking, and their service life may be short.

Notes

2. When the remote controllable distance becomes short, replace both of the batteries with new ones.

3.

If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.

In such a case, change the installation position to avoid malfunction.

Application section

Knowledge sections

Page 14
Image 14
Kenwood XD-550 Operation of remote control unit, Loading batteries, Remove the cover Insert batteries Close the cover