Let's record 2 7
Selection of the reverse mode
REV. MODE
Each press switches the modes as follows.
1 “[” ... Both sides are played back (recorded), and then the tape stops.
2“Ó” .. Both sides are played back endlessly. (The tape stops after recording onto both
sides.)
3“Ò” .. Only one side is played back (recorded), and then the tape stops.
To end recording
REC/ARM
÷Pressing the key pauses recording after leaving a
÷If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes from that instant.
Selection of DOLBY NR (Noise Reduction)
The Dolby NR system minimizes the hiss noise heard when playing tape. When playing a tape prerecorded with Dolby NR ON, be sure to set the DOLBY NR ON for playback.
Lit when “DOLBY NR” is ON.
EX.BASS | ECHO |
DOLBY NR
T A P E
DOLBY NR 
B
Each press switches the modes as follows.
1 “DOLBY NR” ON. ..... DOLBY NR is used.
2“DOLBY NR” OFF ..... DOLBY NR is not used.
Preparation section
4.Select the source to be recorded.
| The input source component to be recorded should be displayed. | |||||
INPUT |
|
| EX.BASS |
| ||
4 |
|
| C D ) 1 : ) ) | |||
|
| |||||
|
|
|
| B | REV | |
| ÷ When the CD input is selected and if a disc | |||||
| has been set in the CD player, its playback | |||||
Select an input source other than “TAPE”. | starts immediately. |
| ||||
5.Start recording.
1Play (or tune) the input source to be
REC/ARM | recorded. | EX.BASS |
|
|
|
| |
| 2Start recording. |
| TOTAL |
| C D ) 1 3: 62 8 1 | ||
|
|
| |
|
| B | REV.MODE |
| 5 |
|
|
| ÷ Recording stops automatically when the tape |
| Lights |
| side(s) to be recorded have been fully recorded. |
|
|
÷The beat cancel function can be used when
recording MW broadcasts. | ¥ |
Basic section
Application section
Knowledge sections
