2Before applying power
| Units are designed for operation as follows. | ||
| Europe and U.K | AC 230 V only | |
| For the United Kingdom | ||
|
| ||
| Factory fitted moulded mains plug | ||
| 1.The mains plug contains a fuse. For replacement, use only a 13- | ||
| Amp | ||
| 2.The fuse cover must be refitted when replacing the fuse in the | ||
| moulded plug. |
| |
| 3.Do not cut off the mains plug from this equipment. If the plug | ||
| fitted is not suitable for the power points in your home or the ca- | ||
| ble is too short to reach a power point, then obtain an appropriate | ||
| safety approved extension lead or adapter, or consult your dealer. | ||
| If nonetheless the mains plug is cut off, remove the fuse and dis- | ||
section | pose of the plug immediately, to avoid a possible shock hazard by | ||
inadvertent connection to the mains supply. | |||
| |||
Preparation | IMPORTANT: The wires in the mains lead are coloured in accord- | ||
Brown | : Live | ||
| ance with the following code: | ||
| Blue | : Neutral | |
Do not connect those leads to the earth terminal of a
Caution : Read this page carefully to ensure safe operation.
Application section
Safety precautions
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
|
|
| CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER |
| CAUTION |
| |
|
|
| (OR BACK). NO |
| RISK OF ELECTRIC SHOCK |
| |
|
| FIED SERVICE PERSONNEL. | |
| DO NOT OPEN |
| |
|
|
|
|
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED
TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE
PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELEC-
TRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.
Knowledge sections
REQUIREMENT BY NEDERLAND GAZETTE
Batteries are supplied with this product. When they empty, you should not throw away. Instead, hand them in as small chemical waste.
The marking of products using lasers
(Except for some areas)
CLASS 1
LASER PRODUCT
The marking is located on the rear panel and says that the compo- nent uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.
