Keurig K10 owner manual Set-Up & Operation continued, CAUTION Do not lift the Handle while brewing

Section 4 Set-Up & Operation (continued)

Let water fully drain into brewer	DO NOT remove foil lid or puncture K-Cup®pack.
5 Sec before lowering the Handle.

2 Min

5

Lift the Handle. Water starts to drain from the Cold Water Reservoir into the brewer.

If you add more than 10 oz., excess water goes into the Drip Tray.

6

Place mug on the Drip Tray.

If you want to use a taller mug, you can slide the Drip Tray out, but you will lose the benefit of the tray to catch the excess water.

7

Insert the K-Cup®pack into the K-Cup®Pack Holder.

Do not add a K-Cup®pack if you are performing the initial cleansing brew.

10

8

Wait until all water has drained (5 seconds) into the brewer before lowering the Handle completely.

9

The BREW Button will flash blue. Press the BREW Button.

!CAUTION: Do not lift the Handle while brewing.

10

The BREW Button will flash red to indicate that the water is heating. After about 2 minutes, the BREW Button will turn solid red when the beverage starts to dispense.

Remove used K-Cup®pack after brewing. CAUTION: K-Cup®pack will be hot.

11

11

Enjoy your beverage! Your brewer is ready to use again or you can power it off.

As a safety feature, brewer automatically shuts off after 90 seconds.

If completing the initial cleansing brew, discard hot water into the sink. Your brewer is ready to use again.