SECTION 6 Troubleshooting
SITUATION | SOLUTION |
Brewer does not have power | • Make sure the Power Button is pressed. The Add Water Indicator should flash blue |
| after pushing the Power Button. Note that the Power Button does not illuminate. |
•During normal operation, the brewer will shut off when it is idle for longer than 90 seconds. Just press the Power Button to restart.
•Plug brewer into an independent outlet.
•Check to be sure that brewer is plugged in securely.
•Plug into a different outlet.
•Reset your home circuit breaker, if necessary.
•If the brewer still does not operate, contact Customer Service.
SITUATION | SOLUTION |
Brewer will not brew when used for the first time | • Brewer may be cold or frozen. Let brewer rest at room temperature for at least 2 |
| hours before powering on. |
•Make sure the brewer has power (see previous page).
Brewer only brews a partial brew | • Allow enough time for water in the Cold Water Reservoir to drain completely into the brewer. |
| • The Exit Needle may be clogged (see page 12). |
| • Clean the |
| • |
| • If you have repeated the |
| function properly, contact Customer Service. |
BREW Button flashes red too long | • Under normal operation, the BREW Button will flash red when the brewer is heating and |
| will turn solid red when brewing. If the BREW Button flashes red longer than 3 minutes, |
| contact Customer Service. |
Add Water Indicator does not flash blue | • If the Add Water Indicator does not flash blue, make sure the brewer has power (see above). |
| • Water may be in the Cold Water Reservoir and brewer. First, try raising the Handle to |
| drain all water from the Cold Water Reservoir into the brewer. If the light still does not flash, |
| power off and place a mug on the Drip Tray. Hold down the BREW Button and continue to |
| hold down until all the water is dispensed into the mug. |
| • If the brewer still does not operate, contact Customer Service. |
Brewer will not brew • Make sure the brewer has power (see above).
•If using reverse osmosis or distilled water, the brewer may not operate correctly. See page 14 for emptying the Internal Hot Water Tank and then use filtered or bottled water.
•Press the Power Button. If the Add Water Indicator flashes blue, add water and attempt to brew. If the brewer loses power during the brew process, the brewer may need to be
•Check that the minimum water level of 6 oz. has been poured into the Cold Water Reservoir.
Brewer shuts off automatically
There is water in the Drip Tray
Red Indicator appears in Drip Tray
•Under normal operation, the brewer will shut off when it is idle for longer than 90 seconds. Just press the Power Button to restart.
•If the brewer shuts off in the middle of a brew (not from power outage), contact Customer Service.
•Remember that any liquid overflow (from your cup or the Cold Water Reservoir) will be caught in the Drip Tray.
•When the Drip Tray is almost full, the red Drip Tray Overflow Indicator will appear. Carefully remove the Drip Tray and empty its contents into the sink.
•This means that the Drip Tray is almost full. Carefully remove the Drip Tray and empty its contents into the sink.
Should other issues arise with your brewer, please call Keurig Customer Service at 1.866.901.BREW (2739).
16 | 17 |
