Tweeter Mounting
Trim Here

Tweeter Mounting

Your tweeter can be flush mounted into your panel with or without the 15° angle

WITH ANGLE RINGS

rings.

Back

Tweeter Angle

Mounting Ring

Nut

Place the

Tweeter tweeter through the

Cut a 1-15/16” (4.9 cm) hole in your panel for the tweeter. Be sure there is clearance behind

15/16" (4.9 cm) Hole

WireWITH ANGLE RINGS

Front Angle Ring and then into the panel.

the panel for the tweeter and wiring.

1-

Panel

 

Front

 

Panel

Angle

Next place the

Ring

 

 

 

Back Angle Ring over the Tweeter and line

Installation

WITHOUT ANGLE RINGS

Mounting

Place the tweeter into

Tweeter

 

 

 

 

Tweeter

 

Nut

 

the panel and secure

 

 

 

by tightening (clock-

Wire

 

 

wise) the Tweeter

 

Panel

 

Mounting Nut.

 

 

 

 

 

up the narrow part of the Back Angle Ring with the wide part of the Front Angle Ring for proper operation.

 

 

Back

Attach the Tweeter

 

Angle

 

Ring

Tweeter

 

Mounting Nut (clockwise)

Mounting

Tweeter

Nut

 

 

 

but do not tighten

 

 

completely.

Wire

 

 

 

 

 

Front

This is what you should end up with after securing the Tweeter to the panel using the Mounting Nut.

Tweeter

Mounting

Nut Tweeter

Wire

Panel

Angle

Ring

 

Rotate all the parts in

unison until the tweeter is angled in the desired direction.

Panel

If necessary, the legs of the Tweeter Mounting Nut can be cut to fit

Secure the assembly by tightening (clockwise) the Tweeter Mounting Nut.

thicker panels. Trim each leg at the score line. Remove only 1 section from each leg at a time until desired length is achieved.

This is what you should end up with after securing the Tweeter to the panel using the Mounting Nut.

Back

Angle

Ring

Tweeter

MountingTweeter

Nut

Wire

Front

Angle

Panel Ring

12

SS Component Systems

Page 12
Image 12
Kicker SS56.2, SS65.2 manual Tweeter Mounting, Installation, With Angle Rings, Without Angle Rings