![](/images/new-backgrounds/1141341/14134113x1.webp)
Installation
AMPLIFIER STRAPPING WITH REMOTE BASS CONTROL
The Remote Bass Level Controller can be used to adjust the output level of both the amplifiers that are strapped together.
1.) Mount the Remote Bass Level Controller in the front of your vehicle and plug in the supplied cable.
2.) Route the supplied cable to the primary amplifier and connect to its BLAST In jack.
3.) Enjoy!
BACK VIEW
SIDE VIEW
SUPPLIED
CABLE
Mounting Surface
SOURCE UNIT
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to send the incoming signal from one Kicker SX series amplifier to another amplifier or processor without the need for Y cables. The signal from the PAST jacks is identical to the signal fed to the amplifier via its RCA input jacks and is not affected by any of the amplifier’s
Most head units with high voltage outputs should be capa- ble of driving up to ten amplifiers in a chain.
SOURCE UNIT
AMP STRAPPING
Installation
AMP STRAPPING
AMP STRAPPING
_
+
AMP STRAPPING
To Next Amplifier or Processor
12 | SX .1 Series Amplifiers | SX .1 Series Amplifiers | 13 |