XB-ROTARY TILLER ASSEMBLY INSTRUCTIONS
STEP 1 With rotary tiller still in crate, lay flat on a level surface. Cut banding straps on the two (2) upright crate posts.
STEP 2 Remove the top & upper side sections of the crate, leaving the rotary tiller resting on the bottom section. You may take the tiller off of crate but you must swing stand arm down and lock in position. (See Figure A and B) Snap stand out of clip, straight out, then swivel the stand down to locked position.
STEP 3 Remove wire tie holding the PTO shaft and set aside PTO.
STEP 4 Attach tiller according to your tractors manual and using the instructions on pages 16 and 17.
STEP 5 Install back plate chain.
STEP 6 Install PTO shaft as outlined in the Attaching to Tractor Section, pg 16- 19.
Note: The safety chains on the PTO shaft should be attached to the tractor and tiller to prevent the plastic safety shield from rotating.
BEFORE PUTTING ROTARY TILLER INTO SERVICE
SHIPPED WITH GEAR OIL IN GEAR BOXES
SHIPPED WITHOUT GREASE IN GREASE FITTINGS.
UNIT MUST BE SERVICED BEFORE USING.
For Top Gearbox use gear oil (type
For Side Gearbox use gear oil (type
• For all Grease Fittings use TYPE/grade II tube grease.
STEP 1 Place rotary tiller so that the deck is secure and level.
STEP 2 Remove Breather Plug (Located at top of transmission gearbox) and check plug located on back of gearbox. (See Figure C.) If oil comes out of check plug replace plug immediately and go to STEP 4, if no oil comes out continue to STEP 3.
STEP 3 Fill gearbox using gear oil (type
8
