6

Hardware Installation

AUI LED

The two-color LED displays two states of operation for the Activity and Partition status on the AUI port. When data is received, the LED will flash green. If the port has been partitioned due to excessive collision or other faulty condition, it will display solid red.

Note: Upon power up, the AUI port LED will not be lit unless a transceiver is attached to the port and there is activity.

BNC LED

The two-color LED displays the Activity and Partition status on the BNC port. When data is received, the LED will flash green. If the port is partitioned due to excessive collision or other faulty condition, it will display solid red.

Note: Upon power up, if the BNC port has no cable attached or is not properly terminated at both ends, the LED will display red to show the port has been partitioned. Upon receipt of good packets, the LED will automatically change from red to green indicating that the port is functioning properly.

UTP Port LEDs

The sixteen or twenty-four UTP Port LEDs offer condition status for Link, Activity, and Partition. If a good link is established on any given port, the green LED will be continuously lit, indicating a valid network connection between the network node and the hub. When data is received, the LED will flash green. If the port is partitioned, the LED will display solid red.

If the LED does not display solid green indicating a good link, check the following:

1.Make sure the power is turned on for both the PC and EtheRx Hub. The power LED should be lit.

2.Verify the network drivers have been loaded from the PC. Some adapters require the drivers to be loaded to establish a proper link.

3.Make sure the correct cable type is selected.

4.Make sure the cable is wired properly and connected on both ends.

5.If steps 1, 2, 3, and 4 are correct, the cable may be defective or not wired correctly. Replace the cable and try again. Please refer to Appendix A for pin assignments and Appendix B for cabling guidelines.

Kingston Technology Company

KNE24TP/RS User’s Guide - Rev. A01

Page 12
Image 12
Kingston Technology KNE24TP/RS, KNE16TP/RS manual Aui Led, UTP Port LEDs